How to Install LED Door Projector Lights in Pakistan — Step by Step

Installing LED door projector lights is one of the easiest car upgrades you can do yourself — no mechanic, no drilling, no special tools. This guide walks you through the complete installation process for any car in Pakistan.

What You Need Before Starting

You need: your LED door projector lights kit, a small flathead screwdriver, and about 20 minutes. The Shift Haus kit includes everything. Order the kit here

Step 1 — Locate the Door Sensor

Open your car door and look along the door frame where the door meets the body. You will see a small pin switch — this is your door sensor. It tells your car the door is open and controls your interior light. This is where you connect the projector light's power wire.

Step 2 — Route the Wire

Thread the projector light's wire through the door panel gap along the lower edge of the door frame. Follow any existing wire channel or rubber grommet. Keep the wire away from hinges.

Step 3 — Connect to the Door Sensor

Tap the power wire onto the door sensor wire using the included connector clip — no cutting or splicing required. Connect the ground wire to any metal bolt on the door frame.

Step 4 — Position and Test

Place the projector unit at the bottom of your door panel pointing downward at a 45-degree angle. Open the door to test — the projection should appear on the ground about 50cm from the car. Adjust angle if needed, then secure with the adhesive pad.

Compatible Cars in Pakistan

This installation works for Toyota Corolla, Honda Civic, KIA Sportage, Hyundai Tucson, Suzuki Swift, Mitsubishi Outlander, BMW 3/5 Series, and virtually any car with a door sensor switch.